Front Wheels; Fitting The Hood - Foppapedretti B9/0407113 Montageanweisungen

GB
TO INSTALL
HOW TO OPEN THE PUSHCHAIR ( fig.1 - fig.2 - fig.3 - fig.4)
Press both the buttons at the side of handlebar "A" and turn the handlebar into positions 1,  or .
A click will indicate that it has been fastened.
Press both the levers (closing hook) "B" and lift the chassis upwards, at the same time press the
rear locking pedal "C" downwards with the foot, until it is completely open.
Make sure the pushchair has been opened correctly by pressing the handlebar at the sides, the
chassis should remain locked in place. If one side has not been locked correctly, grip the handlebar
on the side that has not been fastened and pull upwards to fasten the chassis correctly.

FRONT WHEELS

Fitting the front wheels (fig.5): Lift the chassis with one hand and insert the front wheels, with
the locking lever turned upwards on the wheel hub. A click will indicate that it has been fitted
correctly. Check that both the wheels have been fastened correctly, if they are pulled downwards
they should not be released.
Removing the front wheels (fig.6): press the locking device, in the lower part of the wheel and
keeping it pressed, remove the wheel from the hub.
REAR WHEELS
Fitting the rear wheels (fig.7): Insert the wheel pin in the hole, a click will indicate it has been
fastened in place. Make sure that the wheel has been secured correctly, it should not come away
when it is pulled outwards.
Removing the rear wheels (fig.8): Press the metal lever on the wheel hub and, at the same time,
remove the wheel.
FASTENING THE SEAT (for use as a pushchair)
Fitting the seat (fig.9 - fig.10): to fit the seat, place it in the position shown in the figure. Line up and
insert the plastic connectors of the seat in the slots provided on the pushchair chassis. Press until a click
is heard indicating that it has been fastened correctly.
WARNING: Before use, always check that both the seat supports are fastened correctly to the chassis.
When the seat is lifted upwards, it must not detach from the chassis.
Removing the seat (fig.11): press button "A" on both sides and remove the seat by lifting it.
FITTING THE BUMPER BAR
Fitting the bumper bar(fig.12): line the bumper bar up with the slots and press on both sides. A
click indicates that it has been fastened correctly.
Removing the bumper bar (fig.13): press button A on both sides of the bumper bar and at the same
time pull to remove it.
Opening the bumper bar on just one side (fig.14): press button "A" on one side of the bumper
bar and pull to open it like a gate.

FITTING THE HOOD

Fitting the hood (fig.15): fasten the hood support to both sides of the chassis.
Fasten the press fasteners of the hood behind the backrest.
Removing the hood (fig.16): pull and release the hood support from both sides of the chassis.
FITTING THE FOOTMUFF
For newborn babies (fig.17): Insert the lower part of the footmuff on the seat of the chassis.
Fold the upper part of the footmuff around the bumper bar.
TUO 17