Safety Precautions - INVENTOR P9VI32-09WF Installationshandbuch

Safety Precautions

Read Safety Precautions Before Installation
Incorrect installation due to ignoring instructions can cause serious damage or injury.
The seriousness of potential damage or injuries is classified as either a WARNING or CAUTION.
This symbol indicates that ignoring instructions may cause death or serious
injury.
WARNING
This symbol indicates that ignoring instructions may cause moderate injury
to your person, or damage to your unit or other property.
CAUTION
This symbol indicates that you must never perform the action indicated.
WARNING
Do notmodify the length of the power supply cord or use an extension cord to power the unit.
Do not
share the electrical outlet with other appliances. Improper or insufficient power supply
can cause fire or electrical shock.
When connecting refrigerant piping, do not let substances or gases other than the specified
refrigerant enter the unit. The presence of other gases or substances will lower the unit's capacity,
and can cause abnormally high pressure in the refrigeration cycle. This can cause explosion and injury.
Do not
allow children to play with the air conditioner. Children must be supervised around the
unit at all times.
Installation must be performed by an authorized dealer or specialist. Defective installation can
1.
cause water leakage, electrical shock, or fire.
Installation must be performed according to the installation instructions. Improper installation can
2.
cause water leakage, electrical shock, or fire. (In North America,installation must be performed in
accordance with the requirement of NEC and CEC by authorized personnel only.)
Contact an authorized service technician for repair or maintenance of this unit.
3.
Only use the included accessories, parts, and specified parts for installation. Using non-standard
4.
parts can cause water leakage, electrical shock, fire, and can cause the unit to fail.
Install the unit in a firm location that can support the unit's weight. If the chosen location cannot
5.
support the unit's weight, or the installation is not done properly, the unit may drop and cause
serious injury and damage.
6.
Do not use means to accelerate the defrosting process or to clean, other than those
recommended by the manufacturer.
7.
The appliance shall be stored in a room without continuously operating ignition sources
(for example: open flames,an operating gas appliance or an operating electric heater)
8.
Do not pierce or burn.
Appliance shall be stored in a well -ventilated area where the room size corresponds to the
9.
room area as specifiec for operation.
Be aware that refrigerants may not contain an odour.
10.
NOTE: Clause 7 to 10 are required for the units adopt R32/R290 Refrigerant.
Page 4
ƒ „