Declaration Of Conformity - Bosch 250 HV Originalbetriebsanleitung

Declaration of Conformity

We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 61010-1,
EN 60825-1 (measurement tool) respectively
EN 60950-1 (battery charger) according to the
provisions of the directives 2006/95/EC,
2004/108/EC, 2006/42/EC.
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
2010
Dr. Egbert Schneider
Senior Vice President
Engineering
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Leinfelden, 04.03.2010
Assembly
Power Supply of the Rotational Laser
Level
Operation with Batteries/Rechargeable
Batteries
Using alkali-manganese or rechargeable batter-
ies is recommended for operation of the meas-
uring tool.
To open the battery compartment 14, turn the
locking knob 15 to position
battery compartment.
When inserting batteries, pay attention to the
correct polarity according to the representation
on the inside of the battery compartment.
Always replace all batteries at the same time.
Only use batteries from one brand and with the
identical capacity.
Shut the battery compartment 14 and turn the
locking knob 15 to the
Bosch Power Tools
Dr. Eckerhard Strötgen
Head of Product
Certification
and pull out the
position.
In case the batteries have been inserted incor-
rectly, the measuring tool cannot be switched
on. Insert the batteries with correct polarity.
Remove the batteries from the measuring
tool when not using it for extended periods.
When storing for extended periods, the bat-
teries can corrode and discharge themselves.
Operation with Battery Pack
Charge the battery pack 13 before using for the
first time. The battery pack can only be charged
with the battery charger 22 intended for it.
Observe the mains voltage! The voltage of
the power supply must correspond with the
data given on the nameplate of the battery
charger. Battery chargers marked with 230 V
can also be operated with 220 V.
Insert the appropriate mains plug 23 for your
mains supply into the battery charger 22 and al-
low it to engage.
Insert the charge plug 24 of the battery charger
into the socket connector 17 of the battery
pack. Connect the battery charger to the mains
supply. Charging the empty battery pack takes
approx. 14 h. The battery charger and the bat-
tery pack are protected against overcharging.
A battery that is new or has not been used for a
longer period does not develop its full capacity
until after approx. 5 charging/discharging cycles.
Do not charge the battery pack 13 each time af-
ter using, otherwise its capacity will be reduced.
Charge the battery pack only when the charge-
control indicator 12 flashes or lights up continu-
ously.
A considerably reduced operating period after
charging indicates that the battery pack is used
up and must be replaced.
If the battery pack is empty, the measuring tool
can also be operated off of the battery charger
22 when connected to a power supply. Switch
the measuring tool off, charge the battery pack
for approx. 10 min and then switch the measur-
ing tool on again with the battery charger con-
nected.
To change the battery pack 13, turn the locking
knob 16 to position
pack 13.
English | 27
and pull out the battery
2 610 A12 916 | (4.3.10)