Declaration Of Ce-Conformity; D- 42327 Wuppertal; 24 340 - WALTHER PILOT PILOT Misch-Automatik Betriebsanleitung

Contents
Exploded drawing

Declaration of CE-Conformity

Listing of replacement parts
1 General
1.1 Identification of Model Version
1.2 Normal Use
1.3 Improper Use
2 Technical Description
3 Safety Warnings
3.1 Safety Warting Symbols
3.2 Generally Applicable Safety Precautions
4 Assembly / Installation
4.1 Mounting of Spray Gun
4.2 Connection of Input Lines
5 Operational Handling
5.1 Safety Warnings
5.2 Starting/Stopping Requirements
5.3 Spray Pattern Test
5.4 Spray Pattern Adjustments
5.5 Retooling of Spray Gun
6 Cleaning
6.1 Safety Warnings
6.2 Cleaning - Complete
6.3 Cleaning - Routine
7 Repairs / Replacements
7.1 Replacement of defective Needle Seal Packings
7.2 Replacement of Nozzles, Needles, Springs and Seals
8 Trouble shooting and Corrective Action
9 Disposal of Cleaning / Servicing Substances
10 Specification Data
2
21
22
24
24
24
25
25
25
25
26
26
27
27
28
28
28
28
29
30
31
31
31
32
33
33
33
34
34
35
20
Declaration of CE-Conformity
We, the manufacturers of the equipment, hereby declare under our sole responsibility
that the product(s) described below conform to the essential safety requirements. This
declaration will be rendered invalid if any changes are made to the equipment without
prior consultation with us.
Manufacturer
WALTHER Spritz- und Lackiersysteme GmbH
Kärntner Str. 18 - 30
D - 42327 Wuppertal
Tel.: +49(0)202 / 787 - 0
Fax: +49(0)202 / 787 - 2217
www.walther-pilot.de • e-mail: info@walther-pilot.de
Type Designation Automatic Two-Component-Spray Gun
PILOT Misch-Automatik
Intended purpose Processing of sprayable media
Applied Standards and Directives
EU-Mechanical Engineering Directives 2006 / 42 / EC
94 / 9 EC (ATEX Directives)
DIN EN ISO 12100-1
DIN EN ISO 12100-2
DIN EN 1127-1
Specification according 94 / 9 / EC
Category 2 Part marking
Authorized with the compilation of the technical file:
Nico Kowalski, WALTHER Spritz- und Lackiersysteme GmbH, Kärntner Str. 18 - 30

D- 42327 Wuppertal

Special remarks :
The named product is intended for installation in other equipment. Commissioning is
prohibited until such time as the end product has been proved to conform to the
provision of the Directives 2006 / 42 / EC.
Wuppertal, the 23rd of February, 2010
i.V.
Name: Torsten Bröker
Position: Manager, Design and Development
This Declaration does not give assurance of properties in the sense of product liability. The safety
instructions provided in the product documentation must be observed at all times.
V 24 340
DIN EN 1953
DIN EN 13463-1
Tech.File,Ref.:
II 2 G c T 5
2409
21