Automatically Charging - ECOVACS ECO D56 Bedienungsanleitung

Automatically charging

• When it finishes cleaning or there is low battery, it would seek
charger in same route as automatic cleaning. To make it easy
for robot to search for charging block, you need to put the
block back to the wall and make sure there is no obstacle wi-
thin 1.5 meters ahead of the infrared receiver. Check carefully
whether there is strong reflector in front of the charger,
such as ground glass, smooth ceramic vase and so on.
• It takes time for robot to seek for the charging block. The re-
serve time differs from the ground situation. Maximum reserve
time is 10 minutes.
• Robot can return to the charger if the ground situation is not
too complicated. Under extreme circumstance, such as, huge
house and complex layout would probably bring difficulty for
robot to seek for charger. In such case, you should help to put
the robot back to charge.
• Take care of the first automatic charging, if you find that
the robot keeps turning in the certain area after trying several
times to seek back, you can help to place it on the charger
and look through the charging.
• Under mode, main brush will stop working and robot can-
not do the cleaning.
• Robot shall stay at the charger when it finishes charging
and it transfer to small currency to charge until you start ope-
rating. If you have set appointment timing cleaning, it would
go out of the charger to do cleaning when it comes to appo-
intment time.
ENG
Enjoy smarter life
ENG - 99