Mode Selection; Automatic Cleaning Mode; Border Cleaning Mode - ECOVACS ECO D56 Bedienungsanleitung

7. MODE SELECTION

Automatic Cleaning Mode

____________________________________________________________________________

Border Cleaning Mode

Status instruction:
The meaning of often used three status here and hence
mentioned is as follows:
Working status: robot is operating by cleaning.
Standby status:
Case one: press
Case two: press
running, it pauses
Case three: lift the robot.
Power off status: it is not power on, or under woring status.
Press key under standby mode, it is power off.
Route description: first going straight ahead, it turns when it
meets obstacle. This status will last until the robot detects that it
shall run of battery and it would turn to back charging status.
If robot detects that there is higher plenty of dust on the staring
point, it will take the route as fan-shaped or spiral route
► Under normal circumstance, it will take spiral rout when it
detects plenty of large particles, and take fan-shaped route when
few of small particles.
► If take this mode, the cleaning coverage would reach maxi-
mum compared by the same size area. We recommend this
mode as common domestic one.
Route description: under this mode, once the robot detects
objects, it would run along it, like wall, to clean until it meets
obstacle and change the former route.
► Under this status, robot helps to remove the corner of wall,
table, sofa and bed.
► The operation of this mode takes around 25 minutes and then
robot goes back to charging block by itself.
key and do not operate.
or any other key on host when robot is
ENG
Enjoy smarter life
ENG - 101