Appointment Timing; Set Appointment Time; Current Time Setting - ECOVACS ECO D56 Bedienungsanleitung

8. APPOINTMENT TIMING

Set appointment time

Tips:
• Selection scope: hour is between 0 and 23,
minute is between 0 - 59
• Under normal circumstance, time display on
LCD shows current time.

Current time setting

Tips:
• Selection scope: hour is between 0 and 23,
minute is between 0 - 59
• Under normal circumstance, time display on
LCD shows current time.
Note
►When power is off, robot will not start work on appointment time .If you have already set
appointment timing cleaning, please turn on the robot and keep it on standby status, even
though it is not operating. Try to make it stay at the charger and check whether it is
connected.
1) After power is on, keep press
for around 3 seconds then start current
time setting. on LCD is light and the
number with time setting is flashing.
2) Set hour and minute via  and
, each time press  will increase one
hour or minute. While decrease one hour
and minute for . For confirm setting and
continue press .
3) When you finish setting time, press
again, and then go to current time
setting.
For example:
Set current
time as
12:07 pm,-
me display
LCD should be:
1) After appointment time setting,
then go to the current time setting. The
disappeared, and the number with
time setting flashing,
2) Set hour and minute  and ,
each time press  will incrase on hour or
minute. While decrease one hour and mi-
nute for  , and then press
3) Then go to the frequency setting
For example:
Set current time
as 12:07 pm,time
display on LCD
should be:
ENG
Enjoy smarter life
ti-
on
will light.
to confirm
ENG - 103