Zero Run On The Quick Span Machines; Calibration Run On Quick Span Balance Machines; Saving Wheel Data Measurements; Saving Data - Nussbaum BM 10-2 Bedienungsanleitung

7.4.3

Zero run on the Quick span machines

The procedure for the zero run is different to that of the
balance machines with the standard clamping means
in that the clamping sleeve is fi tted on the shaft.
The shaft should be actuated outwards and the sleeve
placed on it up to the second groove from the left, after
which the shaft is actuated to the closed position.
7.4.4 Calibration run on Quick Span balance
machines
As with the zero run, the calibration procedure is done
with the clamping sleeve fi tted on the shaft.
The shaft should be actuated outwards and the sleeve
placed on it up to the second groove from the left, after
which the shaft is actuated to the closed position.
62
8.

Saving wheel data measurements

Any wheel data and respective program can be sa-
ved using a special program and can be recalled later
when required.
A total of 20 positions are available numbered from 0 to
19 on the program.
8.1

Saving data

The saving mode can be entered using key 16. A posi-
tion can be chosen using the keys +/- (4/5). Once the
position for saving the information has been decided,
press key 12 (enter) to save the data.
Display:
8.2

Retrieving wheel data

Wheel data can be retrieved by pressing key 17. Choose
the desired position by using the keys +/- (4/5). Once
the position has been found, select by pressing key 12
(Enter) and the wheel data is transferred from the me-
mory to the display.
Saved wheel data cannot be deleted, but only over-
written by new data.
till
27.10.2011 1 689 979 917N