Program D - Alu 2; Program E - Alu 3 - Nussbaum BM 10-2 Bedienungsanleitung

5.3.1.2 Program D - ALU 2

For alloy rims with adhesive wheel weights below the rim
edge and on the inner side of the rim
2 2
3 3
BM 10-2 / 11 / 20-2 / 30-2 / 40-2 / 50-2
The distance between machine and rim is automatical-
ly detected.
Extend the outside gauge to the position 2 and hold in
place until an audible signal is heard.
Move the inside gauge directly to position 3 and hold
until another audible signal is heard.
Return the gauge to the home position.
Another signal indicates that it is in the home position.
BM 10-2
Enter rim diameter manually via the +/- button.
The actual value is automatically stored when ano-
!
ther button is pressed or the wheel guard is closed
to start the measuring run.
BM 11 / 20-2 / 30-2 / 40-2 / 50-2
The rim diameter is automatically detected together
with the distance by the inner gauge arm.
! The rim width is not of meaning in this balancing pro-
gram.
1 689 979 917N 27.10.2011

5.3.1.3 Program E - ALU 3

For alloy rims with clip on wheel weights on the rim edge
and adhesive wheel weights on the inner side of the rim
1 1
3 3
BM 10-2 / 11 / 20-2 / 30-2 / 40-2 / 50-2
The distance between machine and rim is automatical-
ly detected
Extend the outside gauge to the position 1 and hold in
place until an audible signal is heard.
Move the inside gauge directly to position 3 and hold
until another audible signal is heard.
Return the gauge to the home position.
Another signal indicates that it is in the home position.
BM 10-2
Enter rim diameter manually via the +/- button.
! The actual value is automatically stored when ano-
ther button is pressed or the wheel guard is closed to
start the measuring run.
BM 11 / 20-2 / 30-2 / 40-2 / 50-2
The rim diameter is automatically detected together
with the distance by the inner gauge arm.
! The rim width is not of meaning in this balancing pro-
gram.
47