Analogue Output - Metz Cosmo 32TZ37 Bedienungsanleitung

Functional overview
TV PVR Archive Radio
Videos Photos Music
HDMI USB Analogue
Manual Remove USB Device Filemanager
Menu
Autom. On/Off Parental control
OK
OK
Sound
O
PERATION LEVEL
■ SIMPLE ■ COMFORT
Sound settings, general Speakers
Sound settings, general
Sound set., prog. posn. Headphone

Analogue output

Analogue output
Digital output
Tone settings
Automatic volume control on
Ton adaption 1) MetzSound
Mute Immediately
BACK
Preset value Channel 1
OK
17.5 Analogue output
It is possible to connect an AV device to the TV using the audio outputs (see page 93-94)
located on the back of the TV.
20:10
Analogue sound can be transmitted from the AV device using a 3.5mm stereo headphone
■ MANUAL
Portal jack.
+
The "Analogue Output" menu need only be configured if the TV uses the AUDIO OUT
Network
port (3.5mm stereo jack) to the AV device, such as HiFi receiver,
wireless headphones, surround decoder, etc.
The "Analogue output" menu and "Sound settings, general" are interconnected.
This interconnection is described on pages 80-81.
Analogue output settings:
• Press
• Select "Menu" with the cursor and press the
• Select "Sound" with the cursor and press the
• Select "Analogue output" with the cursor in the context menu and press the
• Press the
constant, Headphone) . Then press the
H H H
• Select „Output level" with the cursor in the context menu and press the
■ EXPERT ■ MANUAL
MAnalogue output variable
• Set the desired setting with the cursor and press the
constant
Headphone
• Press the
EXIT
button to open the "Functional overview".
button and use the cursor to select the desired parameters (variable,
EXIT
button to exit the menu.
65
button.
button.
button.
button.
button.
button.