Technical Data - SUHNER ABRASIVE USC 25-R Originalbetriebsanleitung

Technical Data

Power input
USC 25-R
USC 9-R
Power output
USC 25-R
USC 9-R
No load speed
USC 25-R
USC 9-R
Sound pressure level according to EN 60745
USC 25-R
USC 9-R
K =
Vibration according to EN 60745
USC 25-R
USC 9-R
K =
Wheel capacity Ø
USC 25-R
USC 9-R
Weight without cord set
USC 25-R
USC 9-R
Double Insulated Class
USC 25-R
USC 9-R
Voltage (refer to spare parts list)
USC 25-R
USC 9-R
Do not use wheels having a maximum
permissible speed below:
USC 25-R
USC 9-R
Warning: The specified vibration value was
measured with a standardised test method and
may differ from the actual operating value. The
specified value can be used for product compa-
risons or for an introductory assessment of work
breaks.
Machine components
1 Spindle neck
2 Gear housing
3 Working spindle
4 Collet
5 Clamping nut
6 Open end wrench 18 mm
7 Open end wrench 14 mm
8 On/Off switch
9 Variable speed selector
Suitable Tools
General: If possible always mount shank in collet
4
500 Watt
500 Watt
300 Watt
300 Watt
11'000-25'000 rpm
4'000 - 9'000 rpm
76 dB(A)
76 dB(A)
3 dB(A)
<2,5 m/s
<2,5 m/s
1,5 m/s
55 mm
55 mm
1,3 kg
1,4 kg
II
II
various
various
25'000 rpm
9'000 rpm
until it bottoms out.
USC 25-R
10 Burs, specialty abrasives,
materials conditioning products
11 Mounted points, Attention: always observe
mounting instructions.
USC 9-R
12 Non-woven Nylon Abrasives, deburring, clea-
ning and finishing tools.
Additional Abrasives and Tools can be found in the
the catalogs.
2
2
2
Safety Instructions
• Do not exceed max. operating speed of tool
and clamping element.
• Observe accurate mounting of tools.
• Secure work, use clamps or vise to hold
work.
• The grinder operator shall wear safety gog-
gles or face shield at all times when the
grinder is in operation.
• If noise level exceeds 85 dB(A) at the work
station, sound insulation and hearing protec-
tion measures must be taken by the operator.
• For additional personal protection, it is advis-
able to connect tool to a ground fault circuit
interrupter,(only in damp areas).
For additional safety instructions refer to enclosed
brochure EW 30003471.
Before Start-up
Voltage Warning
Before connecting tool to a power source, be sure
the voltage supplied is the same as specified
on the name plate of the tool. The power supply
should not vary more than 10% above or below the
voltage indicated on the nameplate.
On-off switch
Before connecting power cord to receptacle, make
sure that switch 8 is in the Off -0- Position.
Operation conditions and instructions
This tool is equipped with an electronic variable
speed tachometer selector and an overload cut-
out switch, which operates as follows:
1. Soft start
2. With increased work pressure more current
GB