Maintenance Table; Problem Identification - Stiga MP2 500 Li D48 series Gebrauchsanweisung

13. MAINTENANCE TABLE

Intervention
MACHINE
Check all fasteners
Safety checks/check controls
Check the rear/lateral
discharge guards.
Check the grass catcher bag
and lateral discharge chute.
Check the cutting means
Check the battery
charge status
Recharge the battery
General cleaning
and inspection
Checking for any damage to
the machine. If necessary,
contact the authorised
service centre.
Cleaning the air filter
Replacing the cutting means
* Refer to the battery/battery charger manual.
** The operation must be carried out by your Dealer or a specialised Authorised Service Centre
*** Operation to be performed at the first signs of any malfunction

14. PROBLEM IDENTIFICATION

If problems persist after having performed the above operations, contact your dealer.
PROBLEM
1. After pressing the start-
er button, the display
does not come ON.
2. After pressing the starter
button, the display does
not come ON and the ma-
chine sets off a buzzer.
Frequency
Before each use
Before each use
Before each use
Before each use
Before each use
Before each use
After each use
After each use
After each use
Once a month
-
PROBABLE CAUSE
Safety key is not inserted or
is inserted incorrectly.
The safety key is not in "OFF" position.
Battery is not inserted or is
inserted incorrectly.
Low battery.
Incorrect battery combination.
Internal motor anomaly.
Insert the key (par. 6.3).
Turn the safety key to "ON" position (par. 6.3).
Open the hatch and check that the battery
is fitted in its housing correctly (par. 7.2.3).
Check the battery status and recharge
if necessary (par. 7.2.2).
Check if the battery combination is
correct, following the instructions
supplied in the "Technical data" table.
Remove the safety key and contact your
Dealer or the Authorised Service Centre
for checks, replacements or repairs.
EN - 13
Notes
par. 7.4
par. 6.2
par. 6.2.1
par. 6.2.1
par. 6.2.1
*
par. 7.2.2 *
par. 7.3
-
par. 7.5
par. 8.1 ***
SOLUTION