Beeps; First Use; Switching The Headphones On/Off - Silvercrest 288642 Bedienungsanleitung Und Sicherheitshinweise

SilverCrest SBTH 4.1 A1

Beeps

For specific events, the headphones emit acoustic signals which are indicated
in the following table:
Event
Power-on procedure
Power-off procedure
Pairing completed
®
Bluetooth connection
established
Incoming call
Minimum volume reached
Maximum volume reached
Low battery charge

First use

Switching the headphones on/off

Switch on the headphones by pressing the ▸ll button (2) for approximately 4
seconds. The LED (8) flashes orange and thus indicates standby mode. If the
headphones were switched on for the first time and had never been connected
to a device, pairing mode is started automatically. The LED (8) alternates
between flashing blue and orange in pairing mode. Read the next section
when connecting your device.
Press the ▸ll button (2) for approximately 4 seconds to switch off the
headphones. The LED (8) flashes orange repeatedly when you switch off the
device.
12 - English
Acoustic signal
Melody
Melody
Melody
Melody
Ringtone
Beep
Beep
4 beeps sound every 20 seconds