Service And Maintenance; Maintenance / Cleaning; Fault Finding / Diagnosis / Repair; Replacing A Defect Mains Fuse - Elektro-Automatik EL 9000 B Slave serie Betriebsanleitung

4.

Service and maintenance

4.1

Maintenance / cleaning

The device needs no maintenance. Cleaning may be needed for the internal fans, the frequency of cleanse is
depending on the ambient conditions. The fans serve to cool the components which are heated by the inherent
minimal power loss. Heavily dirt filled fans can lead to insufficient airflow and therefore the DC input would switch
off too early due to overheating or possibly lead to defects.
Cleaning the internal fans can be performed with a vacuum cleaner or similar. For this the device needs to be opened.
4.2

Fault finding / diagnosis / repair

If the equipment suddenly performs in an unexpected way, which indicates a fault, or it has an obvious defect, this
can not and must not be repaired by the user. Contact the supplier in case of suspicion and elicit the steps to be
taken.
It will then usually be necessary to return the device to Elektro-Automatik (with or without warranty). If a return for
checking or repair is to be carried out, ensure that:
• the supplier has been contacted and it is clarified how and where the equipment should be sent.
• the device is in fully assembled state and in suitable transport packaging, ideally the original packaging.
• optional extras such as an interface module is included if this is in any way connected to the problem.
• a fault description in as much detail as possible is attached.
• if shipping destination is abroad, the necessary customs papers are attached.
4.2.1

Replacing a defect mains fuse

The device is protected by a fusible which is inside a fuse holder on the rear of the device. The fuse rating is printed
next to the fuse holder. Replace the fuse only with one of same size and rating.
4.2.2

Firmware updates

Firmware updates should only be installed when they can eliminate existing bugs in the firm-
ware in the device or contain new features.
The firmware of the control panel (HMI), of the communication unit (KE) and the digital controller (DR), if neces-
sary, is updated via the rear side USB port. For this the software "EA Power Control" is needed which is included
with the device or available as download from our website, together with the firmware update, or upon request.
EA Elektro-Automatik GmbH
Helmholtzstr. 31-37 • 41747 Viersen
Germany
Fon: +49 2162 / 3785-0
Fax: +49 2162 / 16230
EL 9000 B Slave Series
www.elektroautomatik.de
ea1974@elektroautomatik.de
Page 38