Herunterladen Inhalt Inhalt Diese Seite drucken

Troubleshooting; Possible Cause - Scheppach HP2500S Original Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für HP2500S:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1

15. Troubleshooting

The following table shows fault symptoms and describes remedial measures in the event of your machine failing to work
properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault
Engine fails to start.
Engine runs erratically.
Engine overheats.
Engine will not stop when
throttle control is positioned
at stop, or engine speed does
not increase properly when
throttle control is adjusted.
Compactor
is
difficult
control
when
(machine jumps or lurches
forward)
No compacting function or
the plate compactor does not
reach the maximum speed
Oil loss from engine or exciter
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
IM_5904613903_HP2500s_191211_new.indd 31
IM_5904613903_HP2500s_191211_new.indd 31

Possible cause

Spark plug wire disconnected.
Out of fuel or stale fuel.
Throttle control lever not in correct
starting position.
Choke not in ON Position.
Blocked fuel line.
Fouled spark plug.
Engine flooding.
Spark plug wire loose.
Unit running on CHOKE.
Blocked fuel line or stale fuel.
Vent plugged.
Water or dirt in fuel system.
Dirty air cleaner.
Dirty air cleaner.
Air flow restricted.
Debris
interfering
linkage.
Too high engine speed on hard
to
ground.
pounding
Shock
absorber
damaged
Damage
on
exciter
compactor
Drive belt too loose and slips on the
pulley
Worn seal
Leaks on housing
Remedy
Attach spark plug wire securely to spark plug.
Fill with clean, fresh gasoline.
Move throttle control lever to start position.
Throttle must be positioned at choke for a cold
start.
Clean the fuel line.
Clean, adjust gap, or replace.
Wait a few minutes to restart, but do not prime.
Connect and tighten spark plug wire.
Move choke lever to OFF.
Clean fuel line. Fill tank with clean, fresh
gasoline.
Clear vent.
Drain fuel tank. Refill with fresh fuel.
Clean or replace air cleaner.
Clean air cleaner.
Remove housing and clean.
with
throttle
Clean dirt and debris.
Set the throttle lever at lower speed.
too
loose
or
Contact specialist dealer
or
plate
Contact specialist dealer
Adjust or replace the drive belt
Contact specialist dealer
GB | 31
12.12.2019 07:33:39
12.12.2019 07:33:39

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis