Rotation Of The Motor Heads; Figure 1: Assembly Position - DAB EVOPLUS B 120/220.32 M Installationsanweisung Und Wartung


The circulator may be installed in heating and conditioning systems on either the delivery pipe or the
return pipe; the arrow marked on the pump body indicates the direction of flow.

Install the circulator as far as possible above the minimum boiler level and as far as possible from bends,
elbows and junction boxes.

To facilitate control and maintenance operations, install an interception valve both on the suction pipe
and on the delivery pipe.

Before installing the circulator, accurately flush the system with only water at 80°C. Then drain the
system completely to eliminate any harmful substance that may have got into circulation.

Assemble in such a way as to avoid dripping on the motor and on the electronic control device during
both installation and maintenance.

Avoid mixing additives derived from hydrocarbons and aromatic products with the circulating water. It is
recommended that the addition of antifreeze, where necessary, should not exceed 30%.

In the event of heat insulation use the special kit (if provided) and ensure that the condensate draining
holes in the motor casing are not closed or partly blocked.
- In the case of maintenance, always use a set of new gaskets.
7.2

Rotation of the Motor Heads

If the circulator is installed on pipes in a horizontal position, it will be necessary to rotate the motor with the
respective electronic device through 90 degrees in order to maintain the grade of IP protection and to allow
the user a more convenient interaction with the graphic interface (see Figure 2)

Figure 1: Assembly position

Never insulate the electronic control device and the pressure sensor.
ENGLISH
ONLY FOR HEATING
IP _ _
29