Software-Update; Replacing Printer Paper; Changing Vacuum Pump Oil - Bosch ACS 752 Originalbetriebsanleitung

en 60 | ACS 752 | Maintenance
14.6 Software update
14.6.1 Firmware
i
The firmware (software) can be updated by way of a
SD card. Further information can be obtained from
customer service.
14.6.2 Vehicle database
i
The vehicle database can be updated annually by
way of a SD card. Further information can be ob-
tained from customer service.
14.7

Replacing printer paper

!
Avoid excessive force so as not to damage the
printer cover.
1. Open the printer cover.
2. Remove old printer paper roll.
3. Fit new printer paper roll.
Fig. 12: Replacing printer paper
1 Printer paper
4. Close the printer cover.
i
To cut the printer paper correctly, pull the paper
towards the tear bar from one side to another.
|
S P00 D00 159 2019-03-01
1
14.8

Changing vacuum pump oil

DANGER – Risk of electric shock from
dangerous voltage!
Electric shocks resulting from contact with
live parts (e.g. master switch, printed cir-
cuit boards) can cause injury, heart failure
and death.
¶
Disconnect the mains plug before open-
ing the ACS 752.
ATTENTION – Risk of burns from hot
surfaces
Contact with the hot vacuum pump surface
will cause severe burns.
¶
Allow the vacuum pump to cool down.
¶
Wear protective gloves.
i
The vacuum pump oil must always be changed
after 10 hours of operation. The prompt
Remove the used oil pump
"
screen when the vacuum pump oil needs changing.
i
Use the vacuum pump oil (item number
SP00100086) as specified by Bosch.
2
Fig. 13: Vacuum pump
1 Sight class
2 Oil fill plug
3 Drain plug
" appears on the
3 1
Robert Bosch GmbH