Error Codes - ECG EDF 6046 QXA++ Bedienungsanleitung

Problem
Yellow or brown film
on interior surfaces
White coating on the
inner surface.
Detergent dispenser
lid does not close
properly
Detergent remained
in the detergent
dispenser trays.
Steam
Black or gray spots on
the dishes.
Water remains on the
bottom of the sink
Water leak from the
dishwasher

ERROR CODES

In the event of a malfunction a corresponding error code appears on the dishwasher control panel using the
LED indicators.
Code
E1
E2
E3
E4
E5
E6
E7
WARNING:
• If there is a water leak, close the water inlet valve and contact an authorized service center. If there is on the
floor of the dishwasher water due to overflow or leak, remove it before restarting the dishwasher.
Possible cause
Coffee or tea spots
Metal deposits in water can
cause pervasive coating
Hard water containing
minerals
The residue of detergent
clogged the lid catch.
The dishes blocked the
dispenser trays.
This is normal
Aluminium utensils have
rubbed against other dishes.
This is normal
Overfilling dispenser or spill of
the rinse aid
The dishwasher is not in level
position
meaning
Open door
Water supply
Water drainage
Temperature sensor
Overflow/leakage of water
Water leakage
Heating element
Corrective action
Use a solution of 1/2 cup of bleach and 3 cups of water and
remove stains manually.
WARNING!
After completing the program, wait before cleaning the
interior surface for at least 20 minutes to let the heating
elements cool down. Otherwise, there is a risk of burns.
Contact your water supplier with a request to install a special
filter.
To clean the interior, use a sponge soaked in detergent for
dishwashers. Use rubber gloves. Never use any other cleaner
than for dishwasher to prevent formation of foaming or suds.
Remove the residue of the detergent from the catch.
Rearrange the dishes.
Certain amount of steam comes through the ventilation
openings during drying and draining of water.
To remove these stains use a mild abrasive cleaner.
Small amount of water on the bottom of the sink prevents
drying of the water seal.
Make sure that you do not overfill the rinse aid dispenser.
Spilled rinse aid can cause excessive foaming and may lead to
overflow. Wipe the spilled rinse aid using wet cloth.
Make sure that the dishwasher is in level position.
Possible cause
Open door during dishwasher running
Water supply malfunction
Water drainage malfunction
Temperature sensor failure
Overflow/leakage of water occurred
Water leakage occurred
Heating malfunction
23