Troubleshooting Tips; Troubleshooting & Tips; Before Calling The Service; Corrective Action - ECG EDF 6046 QXA++ Bedienungsanleitung

TROUBLESHOOTING TIPS

BEFORE CALLING THE SERVICE

The commendations in the following table may help you solve the problem. If the problem persists, contact
an authorized service center.
Problem
The dishwasher does
not start.
The drain pump does
not stop.
Noise
Foam in the
dishwasher tub
Coloured interior of
the tub
The dishes and cutlery
are not clean
Spots and film on
glasses and cutlery
Coating on glassware.
22
Possible cause
There is a blown fuse or
a tripped circuit breaker.
The power is not on.
Too low water pressure
Overflow
Certain sounds are normal
during washing
Dishes are not properly
secured in baskets or a small
object fell into the basket.
Motor noise
Wrong detergent
Rinse aid overflow
Detergent with dye was used.
Unsuitable program was
selected
Improper loading of dishes in
the baskets
1. Very hard water
2. Low temperature
3. Too many dishes in the
dishwasher
4. Incorrectly loaded dishes
5. Old or wet detergent
6. Empty rinse aid dispenser
7. Incorrect dosage of the
detergents
The combination of soft water
and an excessive amount of
detergent.

Corrective action

Replace the fuse or switch back the breaker. Disconnect all
electrical appliances plugged into the same outlet circuit.
Make sure the dishwasher is turned on and the door is properly
closed. Make sure that the power cord plug is securely plugged
into the wall outlet.
Make sure the water supply is connected properly and the
intake valve is open.
The system is designed to detect an overflow condition. In this
case, the circulation pump stops and the drain pump starts.
Sound of opening the lid of the detergent dispenser.
Make sure that all the dishes in the dishwasher are properly
secured.
The dishwasher was not used regularly. If you rarely use the
dishwasher, do not forget every week to fill and drain water to
prevent drying of seals.
Use only detergents designed for automatic dishwashers. In
the case of foam, open the dishwasher door and let the foam
evaporate. Pour into the tub about 4.5 litres of cold water.
Close the dishwasher and run the program "soaking" to drain
the water. Repeat if necessary.
Wipe the spilled rinse aid immediately.
Make sure that the detergent used does not contain dyes.
Select a more intensive program.
Make sure that the effects of the detergent dispenser and
spray arms are not blocked by large dishes.
Removing spots from glass:
1. Remove all metal cutlery
2. Do not replenish detergent
3. Select the longest program
4. Run the dishwasher and let it run for about 18 to 22 minutes
before coming into the main wash.
5. Open the door and pour in 2 cups of white vinegar.
6. Close the door and let the dishwasher finish the program. If
the vinegar does not help: Repeat the above procedure, but
instead of vinegar, use 1/4 cup (60 ml) of citric acid crystals.
If you are using soft water, use less detergent for glass washing
and select a shorter program.