Detergents - ECG EDF 6046 QXA++ Bedienungsanleitung

Detergent dosage
Fill the dispenser with detergent. Markings indicate the correct dose,
as shown:
1 Compartment for detergent for the main washing cycle. The
value "MIN" represents about 20 g of the detergent.
2 Compartment for the detergent for the pre-wash cycle, about 5 g
of the detergent.
When dispensing and storing detergents, make sure to follow the
manufacturer's instructions on the packaging.
Push the lid until it locks.
If the dishes are heavily soiled, fill the detergent compartment of the prewash cycle also. The agent will start
to work during prewash.
Note:
• In the program table you will find information about dosage of detergent for each program. Please note
that due to the degree of soiling of the dishes and the hardness of the water some differences may occur.
• Read the recommendations of the manufacturer on the detergent's packaging.

DETERGENTS

There are three kinds of detergents
1. With phosphates and chlorine
2. With phosphates without chlorine
3. Without phosphates and without chlorine
New powder detergents usually do not contain phosphates. For this reason there is not water softening by
phosphates. In this case it is recommend to fill the salt container, even if the water hardness is only 6°dH. When
using phosphate-free detergent with hard water, white spots often appear on the dishes and glass. In this case
you can achieve better results, when you add larger amount of detergent. Chlorine-free detergents bleach
less. Dark coloured stains may not be removed completely. In this case, run a program with higher working
temperature.
Using the "3 in 1" tablets
General recommendations
These products are detergents with integrated rinse aid and softener (salt).
1. You should make sure prior to using these products that the hardness of your water allows the use of the
tablets (see the recommendation of the manufacturer on the product package).
2. These products should be used exactly according to the manufacturer's instructions.
3. If you would encounter problems when using "3 in 1" the first time, contact the customer support of the
manufacturer.
Special recommendation
• When using combined products, the rinse aid and the softener are not effective. It could be useful to set
the lowest possible water hardness.
Selecting the "3in1" function
1. Press the power button to turn on the dishwasher and select the washing program 3in1 (press the 3in1
button, so that indicator starts flashing).
2. Press Start/Pause to start the program 3in1. The indicator 3in1 will be on.
1
2
4 3
2
5
6
MAX
1
13