Safety Instructions For Batteries / Rechargeable Batteries; Preparation; Required Tools And Material; Assembling The Lamp - LIVARNOLUX IAN 316949 Montage-, Bedienungs- Und Sicherheitshinweise

For your safety
Do not leave the product or packaging material
lying unattended. The packaging material pre-
sents a suffocation hazard and there is a risk of
loss of life from strangulation.
Always be attentive! Always pay attention to
what you are doing and always proceed with
caution.
Never use the light if you are having difficulty
concentrating or do not feel well.
Familiarise yourself with all instructions and di-
agrams in this manual as well as with the light
itself before use.
The light bulbs used are not
dimmable.
Safety instructions for
batteries / rechargeable
batteries
DANGER TO LIFE!
Keep batteries / rechargeable batteries out of
reach of children. If accidentally swallowed seek
immediate medical attention.
DANGER OF EXPLOSION!
Never recharge non-rechargeable batteries.
Do not short-circuit batteries / rechargeable
batteries and / or open them. Overheating,
fire or bursting can be the result.
Never throw batteries / rechargeable batteries
into fire or water.
Do not exert mechanical loads to batteries /
rechargeable batteries.
Risk of leakage of batteries / rechargeable
batteries
Avoid extreme environmental conditions and tem-
peratures, which could affect batteries / recharge-
able batteries, e.g. radiators / direct sunlight.
If batteries / rechargeable batteries have leaked,
avoid contact with skin, eyes and mucous mem-
branes with the chemicals! Flush immediately
8 GB
the affected areas with fresh water and seek
medical attention!
WEAR PROTECTIVE GLOVES!
Leaked or damaged batteries / rechargeable
batteries can cause burns on contact with the
skin. Wear suitable protective gloves at all times
if such an event occurs.
In the event of a leakage of batteries / recharge-
able batteries, immediately remove them from
the product to prevent damage.
Only use the same type of batteries / recharge-
able batteries. Do not mix used and new bat-
teries / rechargeable batteries.

Preparation

Required tools and material

The tools and materials specified are not included.
This information and these values are non-binding
and are only provided as a reference. The nature
of the material is determined by the individual local
conditions.
- Pencil / marking tool
- Screwdriver
- Electric drill
- Drill bit
- Spirit level
- Ladder

Assembling the lamp

Note: Please remove all packaging material from
the product before assembly.
Note: When the lamp is mounted at a height of
approx. 2.25 m, the maximum range of the sensor
is 4–8 m.
2
The sensor detection angle is 100 °.
2
Note: Choose a sunny location for the LED solar
spotlight.
Note: You can change the orientation of the
spotlights by swivelling them horizontally and
3
vertically (see Fig. A).