Xbpi Waagenparameter Tabellen - Sartorius PR5610 Handbuch

PR5610 Installationshandbuch

4.7.5 xBPI Waagenparameter Tabellen

In den folgenden Tabellen werden die unter [Config]-[Scale], [Config]-[Appl] und [Config]-[Interf]
einzugebenen Parameter aufgelistet. Je nach Waage können nicht alle Parameter gewählt werden. Wenn dies
der Fall ist, erscheint die Meldung
Ambient conditions :"
"Very stable cond. "
"Stable conditions "
"Unstable cond. "
"Very unstable cond"
"Application/Filter :"
"standard mode
"manual filling "
"automatic dosing "
"checkweighing
"Stability range :"
" 0,25 digit"
" 0,5 digit"
" 1 digit"
" 2 digit"
" 4 digit"
" 8 digit"
"Stability symb.delay:"
"no delay "
"short delay "
"long delay "
"extrem long delay "
Sartorius
not valid for scale.
"Tare parameter :"
"at any time
"not until stable "
"Auto zero function :"
"Auto Zero on
"Auto Zero off
"
"Adjustment function :"
"ext.adj.w.fact.wt."
" "ext.adj.w.user.wt."
"ext.adj.w.pres.wt."
"internal adjust "
"ext.lin.w.fact.wt."
"ext.lin.w.pres.wt."
"Confirm preload "
"Delete preload "
"adjust disabled "
"Confirming adjust. :"
"automatically
"manual
"Zero range :"
" 1% of max load "
" 2% of max load "
" 5% of max load "
"10% of max load "
[Scale]
"
"
"
"
"
Inbetriebnahme
"Power-On zero range :"
"factory settings "
" 2% of max load "
" 5% of max load "
"10% of max load "
"20% of max load "
"Power-On tare/zero :"
"activ "
"inactiv "
"only for zeroing "
"Measure rate :"
"normal output
"fast output "
"Calibration check :"
"Off "
"Calibration prompt"
"External Adjustment :"
"Accessible "
"Blocked "
"Maximum capacity :"
"reduced by preload"
"constant
"
"
DE-91