Method 1
A. Keep the cleaner in standby mode.
B. Press the "
„ button for 6s till indicator blinks, meanwhile, press "
release both buttons till beep sounds heard.
Beep sounds mean paired successfully.
Method 2
In off mode, press „
heard.
Remarks:
If no beep sounds heard during above operations, it means failure of pairing.
Please repeat the above procedures.
4.6 USE OF MAGNETIC BOUNDARY STRIP (applies for type ETA 1512)
Attention please! Always put the magnetic boundary strip FLAT on the ground to make it
effective. Cut off the extra length when need.
Use the Magnetic Boundary strips to quickly and easily create "no-go zones" to keep
ROBOT out of the areas you would like it to avoid.
These may include:
• Near power cords that might cause tangles
• Fragile objects that may be damaged.
• Doorway thresholds. Your robot can easily climb over most common thresholds.
However in some situations they may present a challenge.
Use the boundary strips to block off these areas.
• Around furniture with low or narrow space that may trap your robot.
„ and „
„at the same time for 3s,it is well paired when beep sounds
ENG - 49
ENG
„button, do not