eta FIDO Bedienungsanleitung Seite 48

ENG
Function Guidelines
Start/Stop (button)
Forward button
Left-turn button
Right-turn button
Backward button
Auto Cleaning button
Edge Cleaning button
Single Room Cleaning
button
Time setting
Scheduling
Auto-charging
Note:
If the remote control fails to respond, please check whether
the battery is low.
If it still does not work after charging, then re-pair again using below
methods.
Function Information
When the cleaner is at any cleaning mode, press the button
to shift it to standby mode.
When setting the time, press this button to hold settings.
Long-press the button and the cleaner will forward; releasing,
it stops moving.
Long-press the button and the cleaner rotates counterclockwi-
se; releasing, it stops.
Long-press the button and the cleaner rotates clockwise;
releasing, it stops rotating.
Long-press the button and the cleaner moves backward less
than 20cm before stop to prevent it from falling off stairs or
anywhere; releasing, it stops moving.
Press the button to be auto-cleaning mode. It will look for the
charge station automatically when finish cleaning.
Press the button to be edge cleaning mode.
It will look for the charge station automatically when finish
edge cleaning.
Press the button to be single-room cleaning mode.
It will look for the charge station for 30mins. automatically
when finish the cleaning.
1. Press this button to adjust the hour. Press it and „
„ :" on the display screen will flash. Then press the up/
down key.
2. Press the left/right-turn key to change into „:
the minute.
3. Please save your settings by pressing „
Pay attention to am or pm when setting time.
1. Press this button to adjust the hour. Press it and „
„ :" on the display screen will flash. Then press the up/
down key.
2. Press the left/right-turn key to change into „:
the minute.
3. Please save your settings by pressing „
Press the button to be recharging mode.
ENG - 48
" and
" to adjust
" the or „ ".
" and
" to adjust
" the or „ ".