Cleaning And Maintenance; Environmental Protection - Concept VS5031 Bedienungsanleitung

EN
ASSEMBLY
ATTENTION!
Pull the power cord out of the socket before assembling or disassembling the unit. The fan may only be used with the
front and rear protective mesh attached (1), (5).
1. Attach the telescopic rod (8) to the base (9).
2. Place the appliance body on the base rod and tighten with a screw.
3. Position the rear protective mesh (5) onto the drive unit so that the pins on the unit correspond with the holes in
the mesh. Use the attachment nut (4) to secure the assembly.
4. Slide the fan (3) onto the motor shaft by positioning the grooves in the fan hub against the shaft tongues.
5. Turn the nut (2) counter-clockwise to fasten the fan.
6. Position the front wire mesh so that the mesh edges fit into the grooves on the inside of the ring.
7. Tighten the fastening ring with the screw.
OPERATING INSTRUCTIONS
Prior to using the unit verify the power cord is intact.
1. Place the appliance on the floor to prevent it from tipping over.
2. Unfold the power cord completely.
3. Set the desired fan angle. You will hear individual stage clicks when setting.
4. Set the desired fan height by loosening the base nut and extending the telescopic rod.
5. Connect the appliance plug to the mains.
6. Switch (C) switches the appliance on.
7. Use the power switch (A) to select the desired fan power (1 = lowest power - 12 = highest power).
8. Press the oscillation button (B) to turn the oscillation on/off.
9. Use the timer button (D) to set the desired ventilation time. From 0.5 to 10 hours at intervals of 0.5 h. From
10 to 12 hours at intervals of 1 h. When the timer function is on, the icon (E) appears on the display to indicate the
active timer.
10. Switch (C) switches the appliance off.
11. After use, unplug the appliance from the mains.
36

CLEANING AND MAINTENANCE

ATTENTION!
Always disconnect the power cord from the socket before cleaning the unit!
The surface of the unit may only be cleaned with a wet cloth. Do not use any detergents or hard objects as they may
damage the surface of the unit!
The front and rear wire mesh should be cleaned frequently to ensure proper operation of the unit.
Never clean the unit under running water; do not rinse or immerse it in water!
The fan disassembly procedure follows the reverse order of the assembly.
SERVICING
Any extensive maintenance or repair requiring access to the inner parts of the product must be performed by an
expert service centre.

ENVIRONMENTAL PROTECTION

• Packaging materials and obsolete appliances should be recycled.
• The transport box may be disposed of as sorted waste.
• Polyethylene bags shall be handed over for recycling.
Appliance recycling at the end of its service life:
A symbol on the product or its packaging indicates that this product should not go into household
waste. It must be taken to the collection point of an electric and electronic equipment recycling
facility. By making sure this product is disposed of properly, you will help prevent the negative effects
on the environment and human health that would otherwise result from inappropriate disposal of
this product. You can learn more about recycling this product from your local authorities, a household
waste disposal service or in the shop where you bought this product.
This product meets all the basic EU regulation requirements that relate to it.
Changes to the text, design and technical specifications may occur without prior notice and we reserve the right to
make these changes.
VS5031 VS5031
EN
37