Analog Cooking Programmer - Franke SMP 86 M ../F Serie Installations- Und Gebrauchsanweisung

CL 85 M / CM 85 M / CR 86 M _/F / SM 86 M _/F / SMP 86 M_/F

Analog cooking programmer

(Fig. 1a, 1b)
CM
TIMER STOP
START
This clock is already set for manual oven use,
therefore cooking is possible even without
adjusting it.
Right knob
X X
Press the right knob to select in sequence
the functions to be activated (timer, end
of cooking, cooking start, time setting),
signalled by the respective LED blinking.
X X
Press this knob briefly to check already
programmed settings (Query), or press it for
about 2 seconds to cancel settings (Reset).
Left knob (right knob for CL)
X X
Turn the left knob (right knob for CL) to set
the hands of the time clock for the function
activated (LED blinking).
LEDs
9 Blinking: ready for setting or signalling
end of function (together with the ringer).
9 Lit: function running.
Timer
X X
To set the timer, press the knob on the right
once (the corresponding LED begins to
blink); then turn the left knob (right knob
for CL) to move the hands in order to set
the duration of cooking time.
X X
Press the right knob again to confirm
the setting; the corresponding LED
changes from blinking to steady.
„ „
The hands will then return to their
original position to indicate the current
time: when the set time is reached,
the ringer sounds. This sound can
be stopped by pressing the right knob.
„ „
The timer does not control oven
heating.
End of cooking
X X
CL
TIMER STOP
START
Note: At the end of cooking, the oven remains
at a temperature close to the previously set
value for several minutes; it is therefore wise
to remove the food from inside so as to avoid
overcooking it.
End of cooking
X X
X X
X X
X X
Setting the time of day
X X
X X
– 11 –
To set the end of cooking time, press
the knob twice (the LED for the
symbol begins to flash); then turn the left
knob (right knob for CL) to move the hands
in order to set the end of cooking time.
„ „
The LED will blink for the next
10 seconds (for possible adjustments),
after which the setting will be acquired
and the LED becomes steady.
„ „
The same effect is obtained by pressing
the right knob twice during blinking.
At the end of cooking, oven heating will
be deactivated and the ringer will sound
for 1 minute; this sound can be stopped
by pressing the right knob.
with delayed start
Delayed start of cooking can only
be activated following the end of a cooking
process; when set, pressing the right knob
confirms the „stop", and activates the
blinking LED for the symbol
Turn the left knob (right knob for CL) to also
set the start of cooking time (naturally this
will be before the end, therefore the hands
can only be moved back).
Confirm by pressing the right knob again.
The data can also be automatically acquired
by allowing the blinking to continue for
10 seconds.
„ „
The LEDs for symbols
will remain lit and the oven will switch
on at the set time, when only the LED
for the symbol
„ „
At the end of cooking, the ringer will
sound for 1 minute; this sound can
be stopped by pressing the right knob.
To set the correct time, just press the knob
three times (the LED for the clock symbol
starts blinking), then turn the left knob
(right knob for CL).
After setting the right time, press the right
knob to confirm.
EN
.
and
will remain lit.