Attaching The Cuff - Silvercrest 322244 Gebrauchsanleitung Und Sicherheitshinweise

You should not eat, drink, smoke or be physically active
in the 30 minutes before each measurement.
Before taking the first blood pressure measurement,
always rest for 5 minutes!
Furthermore, if you wish to take multiple measurements
one after the other, always wait at least 1 minute between
each measurement.
Repeat the measurement process if the measured values
seem incorrect.
Bring the device to room temperature before the meas-
urement.

Attaching the cuff

ATTENTION! The device may only be used in conjunction
with the original cuff provided. The cuff is suitable for an
upper arm circumference of between 22 and 42 cm.
Place the cuff
1
flow of the arm should not be constricted by clothing etc.
which is too tight.
Position the cuff
edge is 2–3 cm up from the elbow and over the artery.
The cuff tubing
palm.
Place the free end of the cuff
tightly, around the arm and close the Velcro strip. The
cuff should not be too tight (fig. E). Check that two
1
fingers can still fit beneath the cuff
on a bare upper arm (fig. D). The blood
on the upper arm so the lower
1
points towards the middle of the
2
1
closely, but not too
(fig. F).
1
GB/CY 21