Intended Use - SQlab Innerbarends 410 Bedienungsanleitung

Intended use

The different models of the SQlab Innerbarends® are designed according to their characteristics for the different fields of application
trekking, touring and MTB riding. They have been tested in numerous laboratory and field trials. The use of an unsuitable Innerbarend®
can under certain circumstances lead to riding errors, falls and accidents.
When describing the intended use, we follow the international categorization ASTM F2043­13, which precisely describes the different
areas of application.
Modelname
SQlab Innerbarends 410/402
®
SQlab Innerbarends 411
®
SQlab Innerbarends 411 ltd. RUH
®
SQlab Innerbarends 411 R Carbon
®
SQlab Innerbarends® 410/402 are to be used exclusively on bicycles under the conditions of category 2 according to ASTM F2043­13 or
a lower category with a maximum system weight (rider + bicycle + luggage) of 120 kg.
Category 2 according to ASTM F2043­13
This is a set of conditions for the operation of a bicycle/component that includes Condition 1 as well as unpaved
and gravel roads and trails with moderate grades. In this set of conditions, contact with irregular terrain and loss
of tire contact with the ground may occur. Drops are intended to be limited to 15 cm (6 in.) or less.
The SQlab Innerbarends® 411 and 411R are to be used exclusively on bicycles under the conditions of category 4 according to ASTM
F2043­13 or a lower category with a maximum system weight (rider + bicycle + luggage) of 120 kg.
Category 4 according to ASTM F2043­13
Bicycles/add­on parts in this category, in addition to the conditions of use specified in categories 1, 2 and 3, may
also be used for downhill runs in rough terrain up to a speed of max. 40 km/h. Jumps and drops can take place
up to a max. height of 122 cm.
On our website www.sq-lab.com in the service area under Downloads, you will find a list of all func­
tional ranges according to ASTM F2043.
Warning
Each component has its load limit, which can be exceeded in extreme manoeuvres. If the Innerbarends are overloaded, this may cause
failure or breakage. Please note the following:
• Never exceed the permissible system and rider weight.
• Only use your SQlab Innerbarends® within the specified ASTM application category or a lower application category (according to ASTM
F2043­13).
• Do an extraordinary inspection after situations with particularly or unexpectedly large force effects, such as after a crash, riding errors or
an accident. In case of doubt, the possibly damaged component should be replaced prophylactically. In such a case, you should play it
safe and ask your SQlab dealer for advice.
• For the protection of third parties, a component that is not immediately and obviously recognisable as defective should be clearly mar­
ked as unusable.
Category according to ASTM F2043-13
Category 2
Category 4
Category 4
Category 4