Preparing The Appliance - Grundig GDK 6470 X Bedienungsanleitung

Installation and Use of the Appliance
• Draw a central point line on the wall, from the
ceiling to the lower side of the hood (Picture
7).
• There is a notch in the middle of the flue
connection plate. Place the central point
of this notch, which is found on the flue
connection plate, on the vertical line you drew
on the wall. Align it vertically and use a pen to
mark the holes to which the flue connection
plate will be installed (Picture 7 / a).
• Drill the marked points with a Ø6mm drill and
insert 2x Ø6mm plastic pins in these holes
(Picture 7 / a).
• Fix the flue connection plate to the wall with
3.9x22 screws (Picture 7 / a).
• To drill hang holes for the hood, stick the
installation template to the surface to which
the product will be installed and mark the
installation holes (Picture 7 / b).
• Drill hang holes with Ø8mm drill and insert the
pins (Picture 7 / b).
• Insert 2x 4.8x50 hang screws, ensuring that
there is a 5 mm space between the screw
head and the wall (Picture 7 / b).

Preparing the Appliance

Picture 8
1. Hanging Plate
2. Hanging Plate Connection Screw
Loosen the connection screws to pull up the
hanging plates found on the body of the appli-
ance and then tighten the screws (Picture 8 / a).
• Open the filter cover.
28
• Remove the metal oil filter.
• If the diameter of the air discharge pipe is
lower than 150 mm, install Ø150/120 mm flue
adapter.
Ø 4,8 x 50mm
Picture 9
Holding the appliance from its body, attach
it to the previously-installed hanging screws
and tighten the screws well (Picture 9).
Fix the appliance to the wall through the
mounting holes inside it, using the two 4.8x50
screws (Picture 9).
Install the aluminium oil filter of the appliance.
If you are going to use the appliance without a
carbon filter, install the air outlet pipe.
WARNING
As the bends and elbows in the
A
aluminium pipe will cause de-
crease in the air suction power,
using these must be avoided as
much as possible.
1- Chimney Clamp
2- Flap Socket