hanseatic 7NM30T0-E111E00 Gebrauchsanleitung Seite 58

Page EN-24 Installation
Installation under a worktop
➍
➌
❺
➋
– Veneers or plastic coverings on the built-
in furniture require heat-resistant adhesive
(100 °C). If the adhesive and surfaces are
not heat-resistant, the covering may warp
and come loose.
– An intermediate shelf is required if a draw-
er is to be installed below the oven.
– The installation recess may not have a rear
panel, at the most it may have an add-on
edge measuring no more than 50 mm.
– The built-in cabinet can be equipped with
either ledges/rails or an intermediate shelf
with ventilation cut-out.
❻
➊
Installation at eye-level
➌
➋
❻
➎
– The installation recess must have the fol-
lowing minimum dimensions:
– Installation under a worktop
❶ min. 600 mm
➋
560 mm
❸
min. 560 mm
➍
min. 580 mm
❺
max. 50 mm
❻
max. 50 mm
– Installation at eye-level
❶ 595 mm
➋
560 mm
❸
min. 570 mm
➍
min. 580 mm
❺
max. 50 mm
❻
max. 50 mm
❼
min. 35 mm
➐
➊