Silvercrest SFR 37 B1 Bedienungsanleitung Seite 38

water. Do not use the device again, but have it checked by a
specialist.
Installation of a residual current device (FI/RCD) with a rated
residual operating current of no more than 30 mA is recom-
mended to provide additional protection. Ask your electri-
cian for advice. The installation should only be carried out
by a qualified electrician.
DANGER! Risk of electric shock
Only connect the plug-in power unit to a properly installed
and easily accessible wall socket, whose voltage corre-
sponds to the specifications on the rating plate. The wall
socket must continue to be easily accessible after the device
is plugged in.
Ensure that the plug-in power unit cable cannot be damaged
by sharp edges or hot surfaces. Do not wrap the plug-in
power unit cable around the device.
When using the device, ensure that the plug-in power unit
cable cannot be trapped or crushed.
When removing the plug-in power unit from the wall socket,
always pull the plug and never the cable.
Pull the plug-in power unit out of the wall socket, ...
... if there is a fault,
... when you are not charging the device, and
... during thunderstorms.
Do not use the device if there is visible damage on the de-
vice, the plug-in power unit, or the corresponding cable.
If the plug-in power unit or the corresponding cable of this
device are damaged, they must be replaced by the manufac-
turer or its customer service department or a similarly quali-
fied person, to prevent any hazard.
36
GB