Inhaltsverzeichnis
Werbung
Or:
T S P
F i
l a m e n t
Where X can be 1, 2 or 3 depending on the TSP
filament selected. The message MAN that appears
at the end of the second row indicates the operation
mode currently set (factory set MANUAL).
To enable the configuration mode to modify the
autostart and the automatic change of the TSP
filament press the MODE and SET keys.
NOTE
Before activating the configuration mode, make sure
that the SUBLIMATION Led is off.
The display shows:
S U B L I M A T I O N
v v v v A U T O S T A R T
The AUTOSTART is factory set on YES. This
enable the automatic restart of the sublimation after
!
a shut down. Press
YES to NO and viceversa. The display shows:
S U B L I M A T I O N
v v v v A U T O S T A R T
Make the selection then press SET key to confirm
the choice.
If a cartridge with multiple TSP is present the display
will show:
T S P
R E C O V E R :
v v v v
A U T O M A T I C
Factory setting is AUTOMATIC, that enables the
automatic change of the TSP filament in case of
fault (if possible). This configuration can be changed
on MANUAL by pressing the
case the display shows:
T S P
R E C O V E R :
v v v v
M A N U A L
In MANUAL configuration, in case of interruption of
the TSP filament, the controller will be in a fault
condition and the sublimation will be interrupted.
X
M A N
:
Y E S
"
or
key to change from
:
N O
!
"
or
key. In this
To confirm the choice press SET key. If no serial
module are mounted on the controller the display
return to the previous message:
v v v v
M i n i
Or:
T S P
F i
Otherwise, if serial module are present on the
controller the display shows:
S E R I A L
v v v v
Where XXX is the serial address currently set, then
the display shows;
S E R I A L
v v v v
X X X X
Where XXXX is the speed of communication
expressed in Baud.
If the RS 232 Computer Interface Card is mounted
on the controller, the message ìSERIAL ADDRESS
XXXî is not displayed.
Operating Mode Selection
The operating mode selection permits the selection
of the mode by means of which the Sublimation
Controller is controlled.
To select the operating mode press the MODE key.
The display shows:
M O D E :
v v v v
M A N U A L
In this operating mode the selection of time, period
and current value of sublimation are set by means
of the control panel.
20
TECHNICAL INFORMATION
T i
- b a l
l
l a m e n t
A D D R E S S
X X X
B A U D
R A T E
B A U D
NOTE
87-900-077-01(B)
v v v v
M A N
v v v v
X
M A N
Werbung
Inhaltsverzeichnis
