Inhaltsverzeichnis
Werbung
!
If the
key is pressed the display shows:
M O D E :
v v v v
A U T O M A T I C
In this operating mode only the sublimation current
value and the pressure threshold are set by means
of the control panel. The sublimation occurs when
the pressure threshold is reached (analog input on
pin 2 of the I/O connector, range 0 to 5 Vdc, coming
from the recorder output of the MultiVac controller
HV module).
"
If the
key is pressed the display shows the
previous message (mode MANUAL).
!
If the
key is pressed the display shows:
M O D E :
v v v v
R E M O T E
In this operating mode only the time and period of
sublimation are set by means of the control panel.
The current value of sublimation is set by means of
a signal incoming on the analog input on pin 2 of the
I/O connector, range 0 to 10 Vdc (0 Vdc = 0 A,
10 Vdc = 50 A).
"
If the
key is pressed the display shows the
previous message (mode AUTOMATIC).
!
If the
key is pressed the display shows:
M O D E :
v v v v A U T O M A T / R E M O T E
In this operating mode the sublimation starts when
the pressure threshold is reached (as in the
AUTOMATIC operating mode).
The current value of sublimation is set by means of
a signal incoming on the analog input on pin 2 of the
I/O connector, range 0 to 10 Vdc.
"
If the
key is pressed the display shows the
previous message (mode REMOTE SET).
!
If the
key is pressed the display shows the first
message illustrated before (mode MANUAL).
To select the desired operating mode press the SET
key. The controller comes back to the normal
operating mode and the display shows one of the
following messages, depending on the source type
selected.
M i n i
T i
S E T
- b a l
l
M A N
Or:
T S P
F i
The message MAN at the end of the second row
can be different. It depends of the operating mode
selected:
− in mode AUTOMATIC the message become
AUT
− in mode REMOTE SET the message become
REM
− in mode AUTOMAT/REMOTE the message
become A/M.
The controller escape automatically from the
operating mode selection before 30 second, if no
selection are made, and return to the normal
operation.
If the MODE key is pressed during the operating
mode selection the Sublimation Controller returns to
the normal operation and the operating mode
remains
that
activation of the operating mode selection.
Sublimation Parameters Setting
The mode by means of which is possible to modify
the
sublimation
selected operating mode (MANUAL, AUTOMATIC,
REMOTE SET and AUTOMAT/REMOTE). In the
following paragraph are described the different
setting for each operating mode.
To display the sublimation parameters menu and to
switch from one page to another, press the
keys.
When the desired parameter is displayed, the value
can be changed as follows:
1) press the SET key
!
2) press
key to increase the value or
decrease the value
3) press SET key to confirm the choice or MODE
key to escape without changing the value. In any
case the controller come back to the normal
operating mode and the display shows one of the
following messages, depending on the source
type selected.
M i n i
v v v v
21
TECHNICAL INFORMATION
l a m e n t
NOTE
previously
selected
before
parameters
depends
T i
- b a l
l
87-900-077-01(B)
v v v v
X
M A N
the
on
the
"
!
or
"
key to
v v v v
M A N
Werbung
Inhaltsverzeichnis
