Maintenance Instructions - Desoutter 2A89-A Bedienungsanleitung

WARNING
IMPORTANT : SLE037
At low speed (speed adjustment 30%) the
number of revolutions of the output shaft is not
constant.
In order not to affect the lifespan of the engine
do not to exceed the torque of 3.7 Nm .
To operate the tool using "Push start" :
Auto – Push start tools:
ESP 7 TOOL programmed PUSH
ESP 7 MODE programmed PUSH
- Forward:
Hold tool around the red (grip) section and then
press the tool against the fastener until the
operation has fi nished.
- Reverse:
Hold tool around the red (grip) section, fi rst press
and hold the reverse button and then press the
tool against the fastener until the operation has
fi nished.
ESP 7 TOOL programmed PUSH
ESP 7 MODE programmed COMBI
- Forward or Reverse:
Hold tool around the red (grip) section, position the
tool onto the fastener, press and hold the Forward
button / Lever / Trigger, (Or Reverse button for
Reverse) and then press the tool against the
fastener until the operation has fi nished.
To operate the tool using manual mode :
ESP7 TOOL programmed MANU
- Forward or Reverse:
Hold tool around the red (grip) section, position tool
onto the fastener and press and hold the Lever or
Trigger for Forward operation (Or Reverse button
for Reverse), until the operation has fi nished.
The fi xing is tightened to the required torque set by
adjusting the tension on the clutch spring (On mechanical
clutch tools), or when the programmed current has been
achieved on the current controlled tools. (Both clutch
adjustment and Current Parameter value has to be
established using suitable torque measuring equipment
to achieve the required torque).
After a tightening or loosening operation, the
tool is available to start again after:
Auto Push - Start tools:
Lifting the tool away from the fastener. (Button /
Lever / Trigger can be held pressed).
Manual and Angle Head tools
Releasing and re-pressing the Forward Button /
Lever / Trigger or Reverse button.
Information on trigger operation (Pistol Grip Tools):
Single operation trigger On / Off (not progressive)
Torque adjustment (To be set up using suitable torque
measuring equipment to achieve the required torque).
Mechanical Clutch:
As depicted on the exploded diagram
Current Control:
Current Parameter(s) to be set up. (Refer to the
ESP 7 Servicing & Operating Instructions).

MAINTENANCE INSTRUCTIONS

Service should be carried out at intervals of 500
hours' use.
When disposing of components, lubricants, etc ...
ensure the relevant safety procedures are carried
out.
Overmould should be wiped clean with a general
purpose, non-aggressive degreasant.
When disposing of components, lubricants,
etc... ensure that the relevant safety procedures
are carried out.
Indicates direction of dismantling.
© COPYRIGHT 2005, CP
All rights reserved. Any unauthorized use or copying of
the contents or part thereof is prohibited. This applies
in particular to trademarks, model denominations, part
numbers and drawings. Use only authorized parts. Any
damage or malfunction caused by the use of unauthorized
parts is not covered by Warranty or Product Liability.
Part no 6159936270
Issue no 00
Series no E
Date 11/2005
Page 15 / 44