Accessories - Desoutter 2A89-A Bedienungsanleitung

Part no 6159936270
Issue no 00
Series no E
Date 11/2005
Page 14 / 44
STATEMENT OF USE
Product is designed for installing and removing threaded
fasteners in wood, metal and plastic. No other use
permitted. For professional use only.
DATA
Class of construction: III
Rated input: 53W
Rated current: 2,2A
Rated voltage: 40VDC
Weight: 0,64Kg - 0,84Kg.
Noise level: < 70 dB(A). (EN 60 745)
Vibration level: < 2.5 m/s². (EN 60 745)
DECLARATION OF
EMISSION:
These declared values were obtained by laboratory type
testing in compliance with the stated standards and
are not adequate for use in risk assessments. Values
measured in individual work places may be higher
than the declared values. The actual exposure values
and risk of harm experienced by an individual user are
unique and depend upon the way the user works, the
workpiece and the workstation design, as well as upon
the exposure time and the physical condition of the user.
We, CP, cannot be held liable for the consequences of
using the declared values, instead of values refl ecting
the actual exposure, in an individual risk assessment in a
work place situation over which we have no control.
REQUIREMENTS
These tools can only be used with an ESP7 controller.

ACCESSORIES

A wide range of accessories are available and suitable
items should be selected from the relevant CP
Catalogue.
ADJUSTMENTS
Perform regular torque accuracy checks.
To set the Hall Effect :
Hold Case Front Grip (PtNo 463683) fi rmly and
unscrew Clutch Case (PtNo 443843).
Hold Rear Case halves fi rmly and remove front
grip by carefully pulling it off. (A slight twisting
action may help loosen it).
Loosen nylon screws securing Hall Effect Assembly
(PtNo 471953).
With a PZ1 Screwdriver, turn the Adjuster Ring
to align the arrows on the Hall Effect Assembly &
Signal Case Assembly (Nº 461353).
NOISE AND VIBRATION
WARNING
When checking the tool functionality, always
replace front grip along with clutch and clutch
case. Damage to the tool may occur if grip not
replaced.
Check tool functions correctly.
If tool does not function, move Hall Effect Assembly
+ or - in 0.5mm steps. (1mm per full turn of the
adjuster ring).
After adjustment, fi t and tighten two nylon screws,
and apply a small amount of Varn-istop (PtNo
440783).
Replace front grip along with clutch and clutch
case. Tighten clutch case (Torque 7 Nm).
Test tool for correct function and check / set
torque.
OPERATING INSTRUCTIONS
WARNING
IMPORTANT: This tool is fi tted with temperature
sensing. If the temperature inside the tool motor
area exceeds a pre set temperature, the ESP7
Controller will disable the tool and display,
ERROR 013.
Should this Error occur, the reason for this must be
established (E.g. Tool being used out side of cycle times
stated, at too higher torque, in too high an ambient
temperature, or tool has become defective etc.).
Note: The Error 013 message will clear and the tool
will be re useable after the internal temperature
has cooled suffi ciently. Alternatively, use another
tool.
With the correct accessory fi tted, connect the tool to the
ESP 7 controller.
Ensure all Forward and Reverse times / Speeds, Current
and special function parameters are programmed
correctly in the "SETUP – MODE" and "PROGRAM
GROUP " parameters to be used for the application (refer
to the ESP 7 Servicing and Operating Instructions).
Note: Default rotation is clockwise (RHD), this can be
changed to anti-clockwise (LHD) in the ESP7
"SETUP – MODE" parameters.