Connecting The System - Yamaha MCR-E410 Bedienungsanleitung

CONNECTING THE SYSTEM

Make sure you read the following procedure and notes carefully before connecting the system. For information on the
speakers (NX-E800), refer to the owner's manual supplied with it.
Note
Do not connect the power cable of the receiver, CD player, or other components to the wall outlet until all cable connections are
completed.
Right speaker
(NX-E800)
1 Connect the CD (L/R) jacks of the receiver to the LINE OUT (L/R) jacks of the CD player using the supplied audio
pin cable.
2 Connect the system connector (TO CDX-E410) jack of the receiver to the system connector (TO RX-E410) jack of the
CD player using the supplied system control cable.
3 Connect the speaker terminals (L) of the receiver to the speaker terminals of the left speaker and the speaker terminals
(R) of the receiver to the speaker terminals of the right speaker using the speaker cables supplied with the speaker set
(NX-E800). See page 13 for details.
y
• The system control connection is used to transmit the remote control signals from the receiver to the CD player.
• If you want to connect an amplifier with a digital input instead of the RX-E410, use the DIGITAL OUT (COAXIAL or OPTICAL)
jacks of the CD player.
12
En
Connecting the System
3
ANTENNA
75
UNBAL.
DOCK
FM
CD
GND
IN
TAPE/MD
OUT
AM
AUX
R L
1
LINE OUT DIGITAL OUT
OPTICAL COAXIAL
L
R
3
SPEAKERS
6 MIN / SPEAKER
R L
SUBWOOFER TO CDX-E410
OUT
2
MAINS
TO RX-E410
Left speaker
(NX-E800)
MAINS
AC OUTLETS
SWITCHED
100W MAX. TOTAL
Receiver (RX-E410)
(Europe model)
CD player (CDX-E410)