Now use the slots in the mounting bracket 14 intended for
the screws 16 to mark the drill holes (Ø 8 mm, depth approx .
40 mm) .
Ensure that you can connect the spotlight 3 using the connection
cable 17 to the solar panel 1 .
Now drill the fixing holes . Before drilling the fixing holes, ensure
there are no gas, water or electrical lines that could be drilled
into or damaged in the area where you will be drilling .
Insert the dowels 15 into the drill holes (Fig . C) .
Attach the mounting bracket 14 using the screws 16 .
Place the solar panel 1 into the mounting bracket 14 (Fig . C) .
Ensure that the solar panel 1 is orientated towards the sun .
Insert the plug 18 into the socket 19 (Fig . D) .
Set the ON/OFF switch 2 on the spotlight 3 to the "ON"
position (Fig . A) .
The rechargeable batteries 11 will now charge when there is
sufficient solar radiation .
When selecting the mounting location for the solar panel 1 , pay
attention to the following:
The solar panel 1 needs to be as directly exposed to sunlight as
possible . Even partial shading of the solar panel 1 during the day
can have a significant influence on charging .
GB/IE
35