LIVARNOLUX HG04465A Montage-, Bedienungs- Und Sicherheitshinweise Seite 34

Now place the spotlight 3 towards the mounting plate 6 .
Ensure that the ball joint of the mounting plate 6 is correctly
inserted into the slot 9 of the spotlight 3 . Then, close the ball
joint cover 7 by tightening the screws clockwise (Fig . B) .
Set the ON/OFF switch 2 on the spotlight 3 to the "ON"
position (Fig . A) .
The rechargeable batteries 11 will now charge when there is
sufficient solar radiation .
For HG04465B:
Remove the mounting plate 6 from the spotlight 3 by loosening
the screws of the ball joint cover 7 (Fig . B) .
Use the slotted holes of the mounting plate 6 intended for the
screws 8 to mark the drill holes .
Now drill the fixing holes (Ø 8 mm, depth approx . 40 mm) .
Before drilling the fixing holes, ensure there are no gas, water or
electrical lines that could be drilled into or damaged in the area
where you will be drilling .
Insert the dowels 5 into the drill holes (Fig . B) .
Attach the mounting plate 6 using the screws 8 provided
(Fig . B) .
Now place the spotlight 3 towards the mounting plate 6 .
Ensure that the ball joint of the mounting plate 6 is correctly
inserted into the slot 9 of the spotlight 3 . Then, close the ball
joint cover 7 by tighten the screws clockwise (Fig . B) .
34 GB/IE