Connecting Several Lights Together; Switching On / Off; Directing The Light; Changing The Bulbs - LIVARNOLUX 285373 Bedienungs- Und Sicherheitshinweise

5. Attach the light using the appropriate mounting
holes or to the screws.
4 8
6. When securing the light using the mounting
holes , the light housing
8
pushed all the way to the left, swing the light
strip forward and tighten the mounting screws.
9
7. Insert the light connector plug of the mains
lead into the light connector socket
13
8. Insert the mains plug of the mains lead
a convenient mains socket. Your light is now
ready for operation.
Connecting several
Q
lights together
CAUTION! Make sure that all under-cabinet lights
are linked together by means of the connecting
cables before inserting the power cable
7
the socket.
Note: Make sure that you only connect a maximum
of 10 linked-up under-cabinet lights of the same
type to one socket.
Install up to 10 lights of the same model next
to each other. To do so, follow steps 1–5 of
the section called "Mounting the lights".
Note: Make sure that the distance between
the lights is not more than 21 cm.
Note: Make sure that the distance between
the lights is not less than 15 cm.
Remove the protective head guard
Insert the connecting cable
necting socket of the light.
5
Insert the second connection of the connecting
cable into the socket
7
Insert the connection of the power cable
into the socket of the outer, left-hand light.
1
Insert the mains plug
light is now ready to use.

Switching On / Off

Q
Switch the ON / OFF switch
on or off.
must also be
3
.
1
into
13
into
13
.
6
into the con-
7
of the other light.
1
13
into the socket. Your
13
to turn the light
2

Directing the light

Q
Never change the direction of the light while it
is switched on.
CAUTION! RISK OF BURNS DUE TO
HOT SURFACES! Do not touch bulb compo-
nents or bulbs as they can reach temperatures
> 60 °C during operation.
Allow the light to cool down completely.
Turn the strip light

Changing the bulbs

Q
DANGER OF ELECTRIC
SHOCK! To replace the bulb
connect the light from the mains circuit. To do this
pull the mains plug on the mains lead
socket.
Allow the lamp to cool down completely.
Use a clean, lint-free cloth when changing light
bulbs .
11
Remove the clips
12
left of the safety glass pane
Pull the protective glass cover
guides on both sides. Place the protective glass
cover carefully to one side.
Rotate the bulb
11
fitting.
O nly use the fluorescent lamps specified in the
chapter „Technical Data".
Insert a new bulb
11
and turn it through ¼ turn to fix it in place.
Check that it is correctly seated.
Shift the protecting glass disk
should indicate outward) again into the guide rail.
Secure the clips
12
safety glass pane
10
Turn the strip light
CAUTION! Make sure that all under-cabinet
lights are linked together by means of the con-
necting cables before inserting the power
7
cable into the socket.
13
Insert the mains plug on the mains lead
into the socket. Your light is now ready for op-
eration.
Preparations for use
into the desired direction.
9
, first of all dis-
11
out of the
13
attached at the right and
.
10
out of the
10
¼ turn and pull it out of the
carefully into the fitting
(smooth page
10
at the right and left of the
.
into the desired direction.
9
13
GB/MT
back
25