Description Of Parts; Technical Data; Safety; Safety Advice - LIVARNOLUX 285373 Bedienungs- Und Sicherheitshinweise

1 Energy-saving under-cupboard light,
Model 14102104L or 14102106L
1 T5 fluorescent tube, 13 W
1 Power cable
1 Connection cable
2 Dowels
2 Screws
1 Operating instructions

Description of parts

Q
Light connector socket
1
ON / OFF switch
2
Light body
3
Mounting holes for wall attachment
4
Connecting socket
5
Protective head guard
6
Connecting cable
7
Mounting holes for underside attachment
8
Pivoting strip light
9
Protective glass cover
10
Bulb (fluorescent tube type)
11
Clip
12
Power cable
13

Technical Data

Q
Operational voltage:
Bulb:
Nominal output:
Dimensions:
Protection class:
Protection type:

Safety

Q

Safety advice

The right to claim under the guarantee shall be ren-
dered invalid in respect of damage caused by the
non-observance of these operating instructions. No
230–240 V∼ 50 Hz
T5 fluorescent tube type
bulb, 13 W
1 x 13 W
(L x W x H)
575 x 84 x 28 mm
II /
IP20
liability is accepted for consequent damage. No
liability is accepted for damage to property or
persons caused by improper handling or non-
observance of the safety advice.
To avoid danger to life
from electric shock
Before connecting it to the mains, always check
the light, the power cable as well as the con-
necting cable if need be for any damage.
Never use the light if you see any damage.
Damaged power cables and
connecting cables are a danger to life as you
could suffer an electric shock.
Before assembly, ensure that the mains voltage
available corresponds to the operating voltage
necessary of the light (see „Technical Data").
Never let the lamp come into contact with
water or other liquids.
Never open or insert anything into electrical
fittings or equipment. Doing this sort of thing can
lead to a serious danger to life from electric
shock.
Touch only the insulated part of the plug when
connecting to or disconnecting from the mains
supply.
If the external flexible cable of this lamp is
damaged, it may only be replaced by a special
cable or a cable that is only available from the
manufacturer or his service representative.
Only connect the under-cabinet light to the
mains current using the original power cable.
Only connect original under-cabinet lights of
the same type (Model 14102104L or
14102106L) with each other. Only use the
original connecting cable supplied to do so.
Connect the under-cabinet lights that are linked
up together to one socket only. Make sure that
you only connect a maximum of 10 linked-up
under-cabinet lights of the same type to one
socket. Otherwise this might overload the con-
nections and cables.
Make sure that all under-cabinet lights are
linked up via connecting cables before inserting
the power cable into the socket.
Introduction / Safety
GB/MT 23