Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Safety /Preparation / Preparations for use
To avoid danger of fire
and injury
RISK OF INJURY! Check every bulb and
lampshade for damage immediately upon un-
packing. Do not operate the light with a defec-
tive bulb or glass cover. If they are, contact the
service point for a replacement.
RISK OF INJURY FROM BURNS! Ensure
the lamp has been switched off and allowed to
cool before you touch it. In this way you will
avoid the danger of burns. Light bulbs develop
a great deal of heat.
Do not touch bulb components or bulbs as
they can reach temperatures > 60 °C during
operation.
Allow the light to cool down completely before
replacing a defective bulb.
Replace defective bulbs immediately. Before
replacing the bulb always remove the mains
plug from the socket.
If a protective glass cover breaks have
it replaced immediately at the service
centre or by an electrician.
Do not operate this light with a dimmer or an
electronic switch. It is not suitable for this mode
of operation.
FIRE HAZARD! Fit the light so that
it is at least 0.2 m away from the
0.2 m
material illuminated. Fire can result
from the development of too much heat.
Never leave the light operating unattended.
Do not allow any objects to cover the light. Fire
can result from the development of too much heat.
Do not allow the lamp or the packaging materials
to lie around unattended. Plastic film or bags,
Styrofoam etc. can turn into dangerous toys for
children.
Working safely
O nly use the fluorescent lamps specified in the
chapter „Technical Data".
Fit the light in such a way to ensure it is protected
from damp and dirt.
24 GB/MT
Make careful preparations for the assembly
and take sufficient time. Clearly lay out all com-
ponents and any additional tools or materials
that might be required so that they are readily to
hand.
Remain alert at all times and always watch
what you are doing. Always proceed with
caution and do not assemble the lamp if you
cannot concentrate or feel unwell.
Preparation
Q
Required tools and materials
Q
The tools and materials mentioned are not included
in the delivery. The details and values given are
non-binding and for guidance only.
The nature of the material depends on the individual
circumstances on site.
- Pencil / Marking tool
- Screwdriver
- Electric drill
- Drill
- Spirit level
Preparations for use
Q
Fitting the light
Q
Note: Prior to installation, verify there is a socket
nearby within reach of the included power cable
1. Measure up the wall or mounting surface for
drilling the holes. Use a spirit level to improve
accuracy.
2. Mark the two mounting holes a distance of
500 mm apart.
3. Now drill the mounting holes (ø approx. 6 mm,
depth approx. 30 mm). Make sure that you do
not damage any electrical cables during this
operation.
4. Insert the supplied dowels into the drilled holes.
Insert the supplied screws into the dowels and
tighten them. Let them project a distance of about
1.3 mm from the wall or mounting surface.
.
13
Werbung
Kapitel
Inhaltsverzeichnis
