Panasonic TY-ST65PB2 Bedienungsanweisung Und Montageanweisungen Seite 4

Requests regarding handling
1) Exercise care when selecting the location for the display because it may discolor or deform due to light
or heat if it is placed where it is exposed to direct sunlight, or near a heater.
2) For cleaning, wipe the display using a soft dry cloth (made of cotton or flannel). If the unit is extremely
soiled, first wipe off soiling with a neutral detergent diluted in water, and then wipe with a dry cloth. Do
not use cleaners such as benzene, thinner or furniture wax because they may cause paint peeling.
(For information on cleaning the display, see the display's instruction manual. If using a chemically-
treated cloth, follow the instructions supplied with the cloth.)
3) Do not affix adhesive tape or stickers to the product. Doing so may dirty the surface of the mobile stand.
Do not allow long-term contact with rubber, vinyl products or the like. (Doing so will cause deterioration.)
4) Do not subject the panel of the display to a strong force or impact.
Precautions for mobile stand assembly and setup work
● To ensure correct display performance and prevent trouble, do not fit at any of the following locations.
• Near sprinklers or fire/smoke detectors
• Where there is a risk of exposure to vibration or impact
• Near high-voltage wires or dynamic power supplies
• Near sources of magnetism, heat, water vapor or soot
• Locations exposed to air blown from heating equipment
• Where droplets of condensation from an air conditioner or other unit may form
● For the display power supply plug, use a power supply outlet that can be reached easily.
● Ensure good air flow so that the ambient temperature does not exceed 40 °C (104 °F). Failure to do this
may cause heat to build up inside the display, resulting in malfunction.
● Fit so there is no contact between the attachment bolts or power cord and any metal inside the wall.
● Spread a soft blanket or cloth over the floor so that the stand and floor will not be marked or scratched
during the assembly and installation work.
● Conduct assembly and installation work on a horizontal and flat surface according to the fitting
instructions.
● When screwing down the parts, ensure that the screws are neither insufficiently tightened nor over
tightened.
● Take sufficient care to ensure safety around you when performing the assembly and installation work or
while moving about during the course of the work.
● Be sure to read and observe the "Safety precautions".
Caution:
This stand is intended for only Panasonic display models.
Use with other apparatus is capable of resulting in instability causing possible injury.
PROFESSIONAL INSTALLATION IS REQUIRED.
PANASONIC DISCLAIMS ANY PROPERTY DAMAGE AND/OR SERIOUS INJURY, INCLUDING
DEATH RESULTING FROM IMPROPER INSTALLATION OR INCORRECT HANDLING.
15