Tightening The Funnel; Rinsing The Water Tank Before First Use - Klarstein Espressionata Gusto Handbuch

EN
26

Tightening the Funnel

Hold the metal funnel below the metal funnel holder and place it in the holder (see
Figure1). Rotate the metal funnel counter-clockwise until it is tight in the holder and the
handle of the metal funnel points to you (see Figure 2 and 3).
The metal funnel only fits in the funnel holder in a certain way. Do not force it to fit.

Rinsing the Water Tank Before First Use

To ensure that the first cup of Espresso will taste excellent, rinse the appliance with warm
water as follows.
The appliance is supplied with a removable tank for easy cleaning.
1 Remove the water tank from the appliance.
2 Fill it with water. The water level must not exceed the MAX mark.
3 Carefully insert the tank back into the appliance.
NOTE: Do not put coffee in the sieve when cleaning for the first time. It is not
required for this operation.
4 Place an empty vessel of appropriate size cup on the drip grid.
5 Make sure the steam knob is at the position 0 and the button
accidental scalding.
6 Connect the power cord of the appliance to a power source.
7 Press the button to turn on the appliance. The indicator POWER will now light.
8 Press the button . The appliance will start pumping water from the water tank.
9 When the water starts flowing out of the outlet, re-press the button
NOTE: You may hear a noise ("a bubbling sound") while rinsing the
appliance for the first time. This is normal, as the appliance releases air. After
about 20 seconds the noise will disappear.
10 The appliance now begins to heat the water.
1 1 The indicator WATER lights up when the water is hot enough to prepare the espresso
and the heating stops.
12 Press the button again.
is off to prevent
to stop.