Grundig GDK 4382 B Bedienungsanleitung Seite 11

Installing your appliance
• Besides; check if a plug is availa-
ble on assembly area of hood (be-
sides, on the accessible area after
assembling the hood) and check
if connecting the hood to outside
(only for the model with aspira-
tion) is possible.
• Finish all required operations re-
lated to wall (e.g. plugging power
plug and/or leaving a hole for dis-
charge hose).
• Wide dowels are available to ena-
ble tightening of hood on a variety
of wall/ceiling type. Additionally,
conformity of material to wall/
ceiling type should be confirmed
by a qualified technician. Wall/
ceiling should be able to sustain
the hood. Do not assemble the
device on tile, plaster or silicon
surfaces. Assemble it only on to a
wall.
• If a panel and/or side wall and/or
furniture exist, check that there
is sufficient place for assembly
of hood and that control panel is
easily accessible.
• Information required for the prep-
aration of the installation place for
your hood is given below.
Assembly Preparation of the
Hood onto the Wall
Mark the surface where assem-
bly template is going to be hung. (
Figure 1)
Affix the installation template onto
the installation place of the hood.
(Figure 2)
ENG
DE
SV
NO
FI
DA
IT
CS
50
11