Concept ZN 8022 Bedienungsanleitung Seite 36

EN
Note:
The
Tag with ironing info
5. Wait until the heating indicator stops shining. Only then has the ironing surface reached the right temperature. The
ironing surface will be heated during ironing. The heating indicator will turn on and off.
6. After use, set the temperature controller to the minimum, unplug the unit from the power source, and let it cool
down. Then pour the remaining water out of the tank.
Anti-dripping function (ANTI-DRIP)
This unit is equipped with a function that prevents water from dripping, i.e. it will automatically stop steaming if the
temperature is too low and water could be dripping from the ironing surface.
Limescale sedimentation preventive function (ANTI-CALC)
This function is based on the filtration of materials from the water used. It softens the used water, which reduces the
sedimentation of limescale in the steam chamber.
Self-clean function
This function allows cleaning small sediments from the steam chamber. Use it once very two weeks.
1. Fill the tank with water (see Filling with Water).
2. Insert the plug into the mains outlet.
3. Set the temperature control to the maximum.
4. Wait until the heating indicator light stops shining.
5. Hold the unit horizontally over a sink or wide water vessel.
6. Push and hold the Self-clean button. Water will pour from the steam holes in the ironing surface, which will rinse
out small sediments from the steam chamber.
Automatic SHUT OFF function - available on model ZN 8009 only
This safety feature allows automatic shut off if the unit is left on a horizontal ironing surface for 30 seconds without
moving, or for 8 minutes in the vertical position without moving.
In these cases the unit will shut off automatically, short beep will be heard, and the automatic shut off indicator will
start blinking.
Note: This function is just a safety measure. For normal use, set the temperature controller to the minimum, and
unplug the unit from the power source.
34
36
symbol on the tag means: "This fabric must not be ironed!"
Fabric type Temperature setting
Synthetic
MIN.
Polypropylene
Polyurethane
Polyamide
Polyester
Viscose
Silk
Wool
Cotton
MAX.
Linen
(ZN 8032) only
Steam setting
DRY
(MAX steam)
ZN 8022 | ZN 8032
EN
ZN8007, 8009