Gaggenau SK 590 Gebrauchsanleitung Seite 5

How to level your
refrigerator
CAUTION
➢ To avoid damage to walls and
flooring, protect soft vinyl or other
flooring with cardboard, rugs or
other protective material.
➢ To avoid damage or breakage to
adjusting bolt, do not use power
tools to correct leveling.
➢ DO NOT adjust refrigerator down to
where the base of the refrigerator
which supports the condenser is
resting on the floor. Doing so may
damage underside components.
4
TOOLS NEEDED:
• " hex head driver
3
⁄
8
• Level
1. R e m o v e
toe grille
and bottom
hinge covers.
2. Turn both front
adjustment screws (A) clockwise to
raise and counterclockwise to lower.
A
3. Turn both rear adjustment screws (B)
clockwise to raise and counterclock-
wise to lower.
B
4. Check with level to verify 6 mm tilt to
the back for proper door closure.
➢ If refrigerator is aligned and stable,
replace toe grille.
FOR PULLOUT DRAWER
ONLY:
1. Turn both stabilizing legs clockwise
until firmly against floor. Turn roller
adjustment screws 2 to 3 times
counterclockwise so that the full weight
of refrigerator rests on stabilizing legs.
Roller
Adjustment
Screw
2. Replace toe grille and bracket
cover(s). See markings on inside of
toe grille to insure proper placement.
• Snap bottom portion into place
first. Press down on top of grille
until top portion snaps into place.
What if my refrigerator
rocks?
➢ Turn rear adjustment screw clockwise
to raise rocking corner.
➢ Replace toe grille.
Stabilizing
Leg