Electromagnetic Compatibility - Viatom Checkme Pro Benutzerhandbuch

Android Capability
Functionality
* : External ECG cable, bandwidth mode set to wide
**: Heart rate is calculated based on average of every 5 to 30 QRS complex.
***: Only for measurement with external ECG cable, bandwidth mode set to wide
8.

Electromagnetic Compatibility

The device meets the requirements of EN 60601-1-2. All the accessories also meet the
requirements of EN 60601-1-2 when in use with this device.
Warnings and Cautionary Advices
Using accessories other than those specified in this manual may result in

increased electromagnetic emission or decreased electromagnetic immunity of
the equipment.
The device or its components should not be used adjacent to or stacked with

other equipment.
The device needs special precautions regarding EMC and needs to be installed

and put into service according to the EMC information provided below.
Other devices may interfere with this device even though they meet the

requirements of CISPR.
When the inputted signal is below the minimum amplitude provided in technical

specifications, erroneous measurements could result.
Portable and mobile communication equipment may affect the performance of

this device.
Other devices that have RF transmitter or source may affect this device (e.g. cell

phones, PDAs, and PCs with wireless function).
Guidance and Declaration - Electromagnetic Emissions
The Health Monitor is intended for use in the electromagnetic environment specified below. The customer or the user of the device
should assure that it is used in such an environment.
Emission tests
RF emissions CISPR 11
RF emissions CISPR 11
Harmonic emissions IEC61000-3-2
Voltage Fluctuations
Emissions IEC 61000-3-3
Guidance and Declaration - Electromagnetic Immunity
The Health Monitor is intended for use in the electromagnetic environment specified below. The customer or the user of the Health
Monitor should assure that it is used in such an environment.
Mobile phone or tablet with Bluetooth 2.1 or above
Data export, data review, waveform replay, trend review, data sharing
Compliance
Group 1
Class B
Class A
/ Flicker Complies
Electromagnetic environment - guidance
The device uses RF energy only for its internal function. Therefore,
its RF emissions are very low and are not likely to cause any
interference in nearby electronic equipment.
The device is suitable for use in all establishments, including
domestic establishments and those directly connected to the
public low-voltage power supply network that supplies buildings
used for domestic purposes.
23