Controls And Safety Features; Controls; Work Area; Safety Features - JAC PICOMATIC 450 Übersetzung Der Originalanleitung

Any maintenance work or replacement of parts must be carried out by a qualified individual.
6

CONTROLS AND SAFETY FEATURES

6.1

Controls:

Your slicer is fitted as standard with an emergency stop button (fig.1, n°5).
Some machines are equipped with a digital display (fig.6) (MRK – MRK ETL – MRF – MRL – MRL
ETL – MRM – MRC) which can be used to:
- Switch on the screen on the machine (fig.6, n°24).
- Switch off the screen on the machine (fig.6, n°26).
- Reset the cut counter on machines with this feature, by pressing the two buttons located under
the ISC logo simultaneously for 5 seconds (fig.6, n°25).
- Reset the oil counter (MRF – MRM) (fig.6, n°27).
- Programme the various settings on the machine (to be done by an approved agent only) (fig.6,
n°25).
This display will show you:
- The number of loaves cut.
- Whether your blades need to be replaced.
- If a safety cut-out has tripped.
6.2

Work area:

The work area is at the front of the machine (fig.3, n°19).
6.3

Safety features:

If your machine is fitted with a top cover, closing it operates machine start-up. Opening it stops the
machine (fig.1, n°1) (MRZ – MRP – MRK – MRK ETL – MRF – MRP – MRQ).
This machine is equipped with:
A safety switch (fig.1, n°10) that prevents the machine from operating if the rear cover (fig.1, n°10)
(MRZ – MRP – MRK – MRK ETL – MRF – MRP – MRQ – MRR) is open.
A safety switch (fig.2, n°18) that prevents the machine from operating if the front cover (fig.2, n°17)
(optional) (MRC – MRC ETL - MRR) is open.
A photoelectric cell (fig.2, n°15) that prevents the machine from operating when the beam is broken
(optional) (MRL – MRL ETL – MRM).
11
English