VOLTCRAFT Retlux RDM 9001 Handbuch Seite 84

Appendix B: General Care and Cleaning
Warning: To avoid electrical shock or damage to the multimeter,
Cleaning
To clean the instrument exterior, perform the following steps:
Wipe the dust from the instrument surface with a soft cloth. Do not
make any scuffing on the screen when clean the LCD. Clean the
instrument with a wet soft cloth not dripping water. It is recommended
to scrub with soft detergent or fresh water. To avoid damage to the
instrument, do not use any corrosive chemical cleaning agent.
Dirt or moisture in the terminals can distort readings. Follow the steps
below to clean your multimeter.
1. Turn the multimeter off and remove the test leads.
2. Turn the multimeter over and shake out the dirt in the terminals.
3. Wipe the contacts in each terminal with a clean swab dipped in
alcohol.
Appendix C: Fuse Replacement
Use the following procedure to replace the fuse.
1. Ensure that the rotary switch is at the
leads and any connectors from the input terminals.
2. Lift the tilt stand and loosen the screws with a suitable Phillips
screwdriver and remove the battery cover.
3. Pry the fuse cover open using a straight screwdriver, replace the fuse.
Use only the fuse of the specified rating (1 A / 250 V).
4. Place the battery cover back in its original position and tighten the
screws.
RDM 9001
ensure that the insides of the casing stay dry at all times.
position. Remove test
16
EN
2016.03 V1.2.1