_ Notes On Frame And Components - ADP Engineering ROTWILD Handbuch

5 _ NOTES ON FRAME COMPONENTS
The following section contains information on the most important components of
your ROTWILD mountain bike or racing bike. The emphasis is on practical informa-
tion.
► Frames
ROTWILD MTB and racing bike frames are hand-
made from premium quality aluminum alloys.
ROTWILD MTBs are available with and without rear
wheel suspension. The frame is the heart of your
MTB/Racing bike. All ROTWILD MTBs are con-
structed with frames to match the stresses of their
intended use.
IMPORTANT: Excessive stresses, accidents or falls may lead to potentially dan-
gerous frame damage. If you should detect damage to your frame, or if you have
had an accident or fall, please contact your dealer as soon as possible!
► Special instructions concerning carbon-frames
Please note, that when being
damaged, there is a fundamental
difference in behaviour between the
materials carbon and aluminum. As
opposed to aluminum, carbon does
not show dents (typical aluminum-
damage-symptoms). The effect of an
impact first occurs on the inside of the
carbon-tube (splice). After a crash the
frame needs to be inspected by your authorized dealer. In case of any evidence of
the carbon-structure being damaged, the frame needs to be replaced.
Smaller damages can be repaired by the use of resin (epoxide). In order to do so, it
is essential to follow the instructions given by the manufacturer. In case of damaged
fibres be very cautious when handling them. There is an eminent risk of injury when
handling fine carbon fibres.
It is essential to repair damages of the paint, in order to prevent the materials from
absorbing moisture. Entering moisture can affect the characteristics of the material
in a negative way: Delamination may occur. As opposed to carbon fibre, resin might
macerate and therefore cause residual stress on the interface between the fibre and
the matrix.
_ 49
ROTWILD 2007/2008 – Änderungen vorbehalten / Subject to change